User Manual Part 2
Link CX-24 User’s Manual
Version 1.0 Page 73 February 2004
DESCRIPTION
"The transmit frequency in MHz."
::= { rfFrequencyEntry 2 }
rfRxFrequency OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The receive frequency in MHz."
::= { rfFrequencyEntry 3 }
-- link_cx_configuration group
rfTxAttenuateControl OBJECT-TYPE
SYNTAX INTEGER {
enabled(1),
disabled(2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"If enabled, attenuates the transmit output level by 40 dB."
::= { link_cx_configuration 1 }
rfAtpcControl OBJECT-TYPE
SYNTAX INTEGER {
enabled(1),
disabled(2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Automatic Tx Power Control mode can be enabled or disabled.
If enabled, the two Link CX-24 radios at opposite ends of the
radio link send each other feedback messages that they use
to adjust their Tx power down to the lowest level that is
consistent with good signal quality."
::= { link_cx_configuration 2 }
rfTxPowerLimit OBJECT-TYPE
SYNTAX INTEGER (-30..0)
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Maximum transmit power level limit at the antenna port, in dBm.
The Tx power limit can be set in 1 dB steps within the range
of -30 dBm to 0 dBm. If Automatic Tx Power Control is enabled
the measured Tx power may be lower than this limit. If Automatic
Tx Power Control is disabled the measured Tx power should be
exactly the same as this target value."
::= { link_cx_configuration 3 }
rfAtpcAddress OBJECT-TYPE
SYNTAX IpAddress
ACCESS read-write