User Manual

3. Amplifier Kit
Each Amplifier Kit Includes:
• Bi-directional remote mounted amplifier
• DC Power Injector
• 12 VDC, 110/220 VAC Power Supply
• Stainless Steel U-Bolts and mounting
bracket for amp
• Installation Manual
Close up of the bracket and mounting
hardware attached to the amplifier.
The following options are also available and must be ordered separately:
DC power cable with 2.1mm plug to flying lead 3 feet long. Used when the
customer provides their own 12 VDC power for the DC injector or amp.
Option to add second power jack on DC injector to enable one 12 VDC PS
that comes with the amp to power both the Injector and the radio or AP.
(Requires a DC jumper cable. See below).
DC jumper cable that connects a radio modem or Access Point to the
second DC power jack on the DC injector box. Radio devices must have a
2.1 mm ID power jack and operate on 12VDC.
Same as above except used for radios and Access Points that have a 2.5
mm ID barrel jack on them.
4. Installation and Cabling Instructions
FCC Notice
To comply with FCC part 15 rules, the proper version of the amp must only be used in systems
that have been FCC certified. The system must also be professionally installed to ensure
compliance with the Part 15 certification. It is the resposibility of the professional installer to
ensure that certified systems be deployed in the United States (or where FCC rules apply).
The use of the amplifier in any other combination (such as co-located antennas transmitting
the same information) is expressly forbidden in accordance with FCC rules CFR47 part
15.204. Please visit our web site (www.ydi.com) to see the systems currently certified by the
FCC.
Several key factors unique to their particular installation determine the power level at the input
of the amplifier. The most important consideration is the cable loss in the transmission cable
between the radio and the pole mounted amp. It is important that the installer understand these
and other factors when installing the system.
If you are not familiar with determining power levels within the transmission system, YDI
engineers will assist you in planning your system including selecting the proper cable and
antenna required.
Page 3
CAB-DC
DUAL-DC
DC-2.1-2.1
DC-2.1-2.5
Page 12
IMPORTANT:
Only mount the
amplifier with the
connectors facing
downward. Do not
mount it with the
connectors facing
sideways or upwards.
FCC ID#: NM5-C111E
Nokia Authorized Antennas
FCC certified systems consist of:
· A2440-xxF amplifier, DC Injector and 12 VDC Power supply
· Nokia C111 WLAN card with the FCC ID#: ORE-C110-C111
· Outdoor Antenna
· Coax Cable (see table)
ledoMepyTannetnA
annetnA
niaG
)iBd(
XAM
PRIE
)mBd(
ecnatsiDEPM
)MC(
4242TPIDYannetnAhsiDdirG428417
1242TPIDYannetnAhsiDdirG125405
81PF54.2AIDYannetnAlenaPtalF812463
51PF54.2AIDYannetnAlenaPtalF519352
21PF54.2AIDYannetnAlenaPtalF216302
71PL54.2AIDYannetnAlenaPgnoL711423
41PL54.2AIDYannetnAlenaPgnoL418332
2142AIDYannetnAinmO216302
0142AIDYannetnAinmO014302
8042AIDYannetnAinmO93302
A21PF4.2AIDY
lenaPtalFdeifilpmA
annetnA
216323
A81PF4.2AIDY
lenaPtalFdeifilpmA
annetnA
812463