OPERATOR’S MANUAL BRAVO 25 Mower Model: 25-101 - Honda 25-201 - Kawasaki Operator’s Manual Read these instructions carefully and make sure you understand them before using the BRAVO 25. P/N 990015-3 Rev.
INTRODUCTION Careless or improper use of this Lawn Mower can cause serious or even fatal injury. Carefully read, understand and follow ALL instructions in this manual as well as the instructions in the included Owner’s Manual for the engine before using the BRAVO 25 Lawn Mower. Allow only competent adults to operate this lawn mower. It is the owner’s responsibility to ensure that all operators of this mower have read and understand the content of this manual.
SAFETY DEFINITIONS In this manual a Safety Alert Symbol followed by the signal words WARNING and CAUTION are used to identify safety information about hazards which can result in death, serious injury and/or property damage. These signal words mean: WARNING indicates a hazard which, if not avoided, could result in death or serious injury. CAUTION indicates a hazard which, if not avoided, might result in minor or moderate injury. NOTICE indicates a message not related to personal injury.
LAWN MOWER SAFETY CONTENTS Content SAFETY PRACTICES FOR WALK-BEHIND MOWERS Page This lawn mower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. Introduction, personal safety ...................... 2 General safety message.............................. 2-3 Registration of the product ………………… 3 I. GENERAL OPERATION 1.
LAWN MOWER SAFETY II SLOPE OPERATION Slopes are a major factor related to slip and fall accidents, which can result in severe injury. Operation on all slopes requires extra caution. If you feel uneasy on a slope, do not mow it. Continued, 1. Mow across the face of slopes; never up and down. Exercise extreme caution when changing direction on slopes. 9. If fuel is spilled on clothing, change clothing immediately. 8.
DECALS AND LOCATIONS These labels warn you of potential hazards that can cause serious injury. Carefully read and understand them. If a label comes off or becomes hard to read, contact Ybravo.com immediately for a free replacement.
ASSEMBLY - SETUP UNPACKING: STEP 2 Slide the upper handle assembly into the two lower tubes. Insert the two carriage screws and use one square washer on each side of the handle tube. Carefully remove the mower from its packaging and check that you have all the following items: Upper Handle complete (2) Lower Handle tubes (red) Mower Bag and Mulch Plug (installed on the mower) Tool kit Engine Owner’s Manual and Warranty Statement Bravo 25 Operator’s Manual.
ASSEMBLY - SETUP STEP 6 To assist with the installation of the drive cable to the lower control bar push the control bar past the spring lock (1) that normally retains the control bar in a comfortable operating position. STEP 4 Insert the throttle cable inside the left handle tube. Install the cable into the throttle control. Adjust the cable to the middle position of the threaded stud and tighten the 10mm nuts.
ASSEMBLY - SETUP STEP 8 Honda Engine Verify that the throttle control is adjusted properly as follows: - Move the throttle control to the Full Throttle position. Full Throttle NOTICE: The engine speed should preferably be checked and verified with a tachometer. Normal full throttle speed of the engine should be adjusted to 3500 to 3600 RPM. An authorized Honda or Kawasaki Engine Dealer can verify and adjust the engine speed properly.
CONTROLS & OPERATION Before operating the mower for the first time, please review and understand the entire manual including all Warnings and Cautions. Even if you have operated other mowers in the past please take time to become familiar with how this mower works and practice all operations to build up your skills.
CONTROLS & OPERATION DRIVE CONTROL HEIGHT ADJUSTMENT The drive system consists of a two speed transmission and an adjustable belt drive from the engine to the transmission. Each wheel can be adjusted individually to a specific cutting height. Note that moving the front wheel height adjusters forward raises the cutting height. Moving the rear wheel height adjusters towards the rear of the mower raises the rear cutting height.
MAINTENANCE Maintenance Service Interval Procedures Before each use Check the engine oil level. Check the operation and integrity of the BBC control system (see page 10). Inspect the mower blade for wear or damage. Inspect the cables for any wear or damage. Inspect the grass catcher for any damage. Check for any loose or missing screws or damaged parts. Clean under the lawn mower deck (after usage). First 20 Hours or Within 4 weeks Change the engine oil (see page 13).
MAINTENANCE BLADE MAINTENANCE For best results, the mower blade must be kept sharp. Always replace a bent or damaged blade. Removing the blade 1. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 2. Turn lawn mower on its right side. (Make sure air filter and carburetor are up). 3. Use a wood block between blade and mower deck to prevent blade from turning when removing blade bolts.
MAINTENANCE BLADE BRAKE CLUTCH CABLE ADJUSTMENT BLADE BRAKE CLUTCH - ALERT SPRING It is recommended that the adjustment of the Blade Brake Clutch (BBC) cable is checked at the minimum every 50 Hours or within each 4 weeks of operation. If not properly adjusted the brake might not work as designed. This adjustment pertains to a belt that has been used a minimum of 2 hours. The mower is equipped with a spring device that can alert the operator of a malfunction of the spring that engages the blade brake.
PRODUCT REGISTRATION & WARRANTY STATEMENT All Ybravo.com products can be registered online at www.ybravo.com quickly and easily. Click on the Product Registration tab and fill out the electronic form and submit. SECTION 1: LIMITED WARRANTY Ybravo.
