Instruction manual

Initial setting

No.

Terminal

Initial Setting

n050

n051

n052

n053

n054

n055

n056

Function

Forward run command (2-wire sequence)

Reverse run command (3-wire sequence)

External fault

Fault reset

Multi-step speed reference 1

Multi-step speed reference 2

JOG command

Terminal function at 3-wire sequence selection

When 0 is set at the terminal S3 (n052), terminal S1 becomes run command,

terminal S2 becomes stop command, and terminal S3 becomes FWD/REV

run command.

• LOCAL/REMOTE selection (setting: 17)

Select operation reference either by the digital operator or by the settings of

run command selection (n003) and frequency reference selection (n004).

LOCAL/REMOTE select is available only during stop.

Open : Run according to the setting of run command selection (n003) or

frequency reference selection (n004).

Closed : Run by frequency reference and run command from the digital

operator.

Run command

(Run when “closed”)

Stop command

(Stop when “open”)

FWD/REV run selection

FWD run when “open”

REV run when “closed”

STOP SW

(NC CONTACT)

RUN SW

(NO CONTACT)

( )

VS-606V7