Instruction manual

RUN

ALARM

(Green)

(Red)

Operation ready

(During Stop)

Normal

Operation

Ramp to

stop

: ON

: BLINKING : OFF: BLINKING (Long Blinking)

NOTE

Description of Status Indicator LEDs

There are two LEDs on the middle right section of the face of the VS-606V7.

The inverter status is indicated by various combinations of ON, BLINKING

and OFF LEDs. RUN indicator and status indicator on the RUN button

have the same function.

For details on how the status indicator LED’s function at inverter faults,

refer to Section 8 “FAULT DIAGNOSIS” on page 134. If a fault occurs,

the ALARM LED lights.

The fault can be reset by turning ON the fault reset signal (or pressing

key on the digital operator) with the operation signal OFF or by

turning OFF the power supply. If the operation signal is ON, the fault

cannot be reset by the fault reset signal.

STOP

RESET