Instruction manual

33
 Operating the Digital Operator
All functions of the VS-606V7 are set by the digital operator. Below are
descriptions of the display and keypad sections.
DIGITAL OPERATOR JVOP-140
STOP
RESET
DSPL
><
RUN
DATA
ENTER
FREF FOUT IOUT
F/R LO/RE
MNTR
PRGM
DIGITAL
OPERATOR
JVOP-140
Function display LED’s
LED switches to another
function each time
DSPL is pressed.
The displayed data can
be changed.
Press to switch
between
function LEDs.
Press to enter the
constant data.
(Displays the constant
data when
selecting constant no.
by PRGM LED.)
Press to increase
constant no./data
value.
Press to stop the motor.
(Press to reset at faults.)
Press to run
the motor.
Data display section Display section
Press to decrease
constant no./data
value.
Operator CN2 terminal
(Color in parenthesis indicates the color of LED.)
Status indicator
(same function with
RUN indicator)
FREF
Frequency reference
setting/monitoring
(GREEN)
FOUT
Output frequency
monitor
(GREEN)
IOUT
Output current
monitor
(GREEN)
F/R
Operator RUN
command FWD/REV
selection
(GREEN)
PRGM
Constant no./data
(RED)
MNTR
Multi-function
monitor
(GREEN)
LO/RE
LOCAL/REMOTE
Selection
(RED)
CN2-1: Operator circuit terminal
(voltage reference)
CN2-2: Operator circuit terminal
(current reference)
CN2-3: GND for Operator circuit terminal
(Rear side of the operater)
Details of LEDs
STOP
RESET
RUN
MIN
MAX
Frequency setting
potentiometer
Changes frequency
setting according to
the potentiometer.
Display section