Instruction manual

120
Operator
display
DY
ED
CPY
VFY
SNO
END
P E
DE
CSE
DPS
CPE
CYE
F04
VRE
FE
Description
Corrective action
Lit: Setting for constant copy function
selection enabled
Lit: READ selected
Blinks: READ under execution
Lit: Writing (COPY) selected
Blinks: Writing (COPY) under execution
Lit: VERIFY selected
Blinks: VERIFY under execution
Lit: Inverter capacity display selected
Lit: Software No. Display selected
Lit: READ, COPY (writing), or VERIFY
completed
Blinks: Attempt to execute READ while
constant read selection prohibit (n177)
is set to 0.
Confirm the necessity to execute READ, then
set constant read selection prohibit (n177)
to 1 to execute READ.
Confirm that the main circuit power supply
voltage is correct, then re-execute READ.
The constans stored in the digital operator
cannot be used.
Re-execute READ to store the constans in the
digital operator.
Check if they are the same product series.
Execute READ.
Confirm that the main circuit power supply
voltage is correct, then re-execute writing
(COPY).
Initialize the constans. If an error occurs
again, replace the inverter due to a failure
of constant memory element (EEPROM)
in the inverter.
Press ENTER to continue the execution of
COPY or VERIFY. Press STOP to interrupt the
execution of COPY or VERIFY.
Check the connection between the inverter
and the digital operator.
If a communication error occurs durring READ
operation or writing (COPY) operation, be sure
to re-execute READ or COPY.
Check each voltage class and control mode.
Blinks: The constant could not be read
properly by READ operation. Or, a main
circuit low voltage is detected during
READ operation.
Blinks: A sumcheck error occurs in the
consant data stored in the digital operator.
Blinks: The password for the connected
inverter and that for the constant data
stored in the digital operator are disagreed.
[Ex.] Writing (COPY) from VS-606V7 to VSmini
J7
Blinks: No constant data stored in the digital
operator.
Blinks: Attempt to execute writing (COPY) or
VERIFY between different voltage classes or
different control modes.
Blinks: A main circuit low voltage is detected
during writing (COPY) operation.
Lit: A sumcheck error occurs in the constant
data stored in the inverter.
Blinks: Attempt to execute COPY or VERIFY
between different inverters of different
capacities.
Blinks: A communication error occurs
between the inverter and the digital
operator.
-
-
-
-
-
-
-
Note: While rEd, CPy, or vFy is displayed by blinking, key input on the digital operator is disabled.
While rEd, CPy and vFy are not displayed by blinking, pressing DSPL or ENTER redisplays the constant No.
Display List
VR