Instruction manual

38
 Wiring the Control Circuits
Pass the cable through wiring hole to connect it. Always mount the
cover in its original position.
S2 can be changed according to sequence input signal (S1 to S7) polar-
ity.
0 V common: NPN side (Factory setting)
+24 V common: PNP side
Refer to pages 234 and 235 for S2.
Insert the wire into the lower part of the terminal block and connect
it tightly with a screwdriver.
0.4 mm max
(0.016 in.)
2.5 mm max
(0.098 in.)
Wiring the Control Circuit Terminals Screwdriver Blade Width
5.5 mm
(0.22 in.)
The wire sheath strip length must be 5.5 mm (0.22 in.).