Instruction manual

194
 Software No. Display
The software number of the Inverter for which constants are stored in
the Digital Operator is displayed.
Example: Displaying Software No. of Inverter for which Constants Are
Stored in EEPROM in Operator
* Displays the lower 4 digits of the software version.
 Display List
Explanation Operator Display
• Enable the setting for
constants n001 to
n179.
• Execute Software No.
Display (Sno)* using
the Constant Copy
Function Selection
(n176).
• Press DSPL to light
[PRGM].
• Press ENTER to display
the set value.
• Change the set value to 4
by pressing the or
key.
• Press ENTER.
• Change the constant No. to
n176 by pressing the or
key.
• Press ENTER to display
the set value.
• Change the set value to
Sno by pressing the or
key.
• Press ENTER.
• Press DSPL or ENTER.
Operator
Display
Description Corrective Action
Lit: Constant copy function selection
enabled.
-
Lit: READ selected.
Flashes: READ under execution.
-
Lit: Writing (COPY) selected.
Flashes: Writing (COPY) under execu-
tion.
-
Lit: VERIFY selected.
Flashes: VERIFY under execution.
-
Lit: Inverter capacity display selected. -
Lit: Software No. display selected. -
(May be a different constant No.)
(Lit)
(Flashes)
(May be a different set value.)
(Lit for one second.)
 (The constant No. is
displayed.)
(Lit)
(Lit)
 (The constant No. is
displayed.)
 (Lit)
(Software version: VSP030010)