Instruction manual

158
14 SEARCH command from
maximum frequency
SPEED SEARCH command
signal
149
15 SEARCH command from set
frequency
149
16 ACCELERATION/
DECELERATION HOLD
command
150
17 LOCAL/REMOTE selection 136
18 Communications/control cir-
cuit terminal selection
162
19 Emergency stop fault,
NO contact input
Inverter stops for an emer-
gency stop signal input ac-
cording to the Stopping
Method Selection (n005).
When frequency coasting to
a stop (n005 is set to 1) is se-
lected, the Inverter coasts to
a stop according to
Deceleration Time Setting 2
(n022).
Digital Operator displays
. (Lit for fault, flashing
for alarm.)
-
20 Emergency stop alarm,
NO contact input
-
21 Emergency stop fault,
NC contact input
-
22 Emergency stop alarm,
NC contact input
-
23 PID control cancel 184
24 PID integral reset 184
25 PID integral hold 184
26 Inverter overheat alert (OH3
alarm)
-
27 Acceleration/deceleration
time selection 2
-
28 Data input from communica-
tions
92
34 UP/DOWN commands Setting enabled only for
n053 (terminal S4)
160
Setting Name Description Ref.