Instruction manual

124

* These input signals can be used from DeviceNet communications only.

There are no corresponding external input terminals.

002CH

Inverter status

Bit 0 Run (1: Run)

1 Zero-speed (1: Zero-speed)

2 Frequency match (1: Match)

3 Minor fault (Alarm indicated.)

4 Frequency detection 1

(1: Output frequency ≤ setting in n095)

5 Frequency detection 1

(1: Output frequency ≥ setting in n095)

6 Inverter ready for operation (1: Ready)

7 Undervoltage detection

(1: Undervoltage being detected.)

8Baseblock

(1: Inverter output baseblock in progress.)

9 Frequency reference mode

1: Not through communications

0: Through communications

A RUN command mode

1: Not through communications

0: Through communications

B Overtorque detection

(1: Overtorque being detected or overtorque error.)

C Reserved.

D Fault restart in progress

E Fault (1: Fault)

F Not used.

Number

Contents