User`s manual

10 Appendix
10-28
∗ These functions are available for the following software versions.
INDEXER module: Version 3 or later
SERVOPACK: Version 001B or later.
Note: A setting may be write-prohibited if the digital operator displays “NO-OP” when any of the above utility function is
executed. For details, refer to the following manuals.
•
Σ -V Series User's Manual Design and Maintenance Rotational Motor/Command Option Attachable Type (SIEP
S800000 60).
•
Σ -V Series User's Manual Design and Maintenance Linear Motor/Command Option Attachable Type (SIEP
S800000 66).
FnB06
*
Program table initialization {
{
(PRMINIT)
{
FnB07
*
ZONE table initialization {
{
(ZONEINIT)
{
FnB08
*
JOG speed table initialization {
{
(JSPDINIT)
{
FnB09
*
Absolute encoder origin setting {
{
(ZSET)
×
FnB0A
*
INDEXER status monitor {
{
(ALM, ERR, IN2,
OUT2, STS, PUN,
PFB, POS, DST,
RPOS, RDST, PGM-
STEP, EVTIME,
LOOP)
{
FnB0B
*
INDEXER parameter setting initialization {
{
(PRMINIT)
{
FnB0C
*
INDEXER alarm reset {
{
(ARES, ALMTRC-
CLR)
{
FnB0D
*
INDEXER alarm history display {
{
(ALMn)
{
{: Available ×: Not available
(cont’d)
Fn No. Function
Operation from
the Digital
Operator
Operation from the
Serial Commands
Operation
from the
SigmaWin+