Specifications

7/201

1.3 Hardware Requirements for MOTOCOM32

The MOTOCOM 32 operates with the configurations shown in Table 1.

Table 1 Hardware Requirements for MOTOCOM32

Microsoft Windows 95 /98 /NT4.0/2000/XP

CPU

Pentium, or pentium compatible processor

Required Memory

16 Mbyte or more

Hardware Disk

Capacity for

Installation

13 Mbyte or more

Disk drive

Hard disk and CD-ROM drive

Display

Supported by MS-Windows

Mouse

Supported by MS-Windows

Robot Controller

NX100, YASNAC XRC, MRC, MRCⅡ, ERC, and ERCⅡ.

Transmission Cable

Ethernet cable or RS232C cable

Hardware Lock Key

Used under single user environment.

For details, refer to the following section “Hardware Lock.”

Notes 1: A personal computer and OS are not included with this software.

2: Use either an RS-232C cable or an Ethernet cable for transmission, depending on the data transmission

function specifications set in the robot controller manuals. Before starting this software, check the

hardware and software specifications of the robot controllers.

3: Ethernet transmission is not available for the YASNAC MRCⅡ/ ERC / ERCⅡ since they do not

support the Ethernet function.

For softwares and devices, refer to the robot controller Operator’s Manuals, Data Transmission

Operator’s Manual, Ethernet I/F Board Instructions, Manuals for MS-Windows, etc.

The cable connection for communications via RS232C is shown in Fig. 1.6.

Note : When using an Ethernet cable, the RS232C cable is not required.

IBM PC/AT

Robot Controller

(D-sub 25-pin male)

Personal Computer

(D-sub 9-pin female)

CS RS