Operator`s manual

70
/
91
[How to Operate]
Refer to “23.9 File Settings”.
If a relay name or register name is changed with this function invalid, an alarm
message appears when the “ladder editing” display is closed. Store the data by
selecting [File] – [Save Relay Label File].
23.4 Automatic Rough Draft File Storing Function
If any interference occurs at editing and the application shuts down before storing
the editing data, Ladder Editor 32NX has a function to create a Rough Draft file
(data file being edited) automatically.
[How to Operate]
Refer to “23.9 File Settings”.
With this function, the data in its current state is stored in a work file when a line is
changed, inserted, or deleted in the “ladder editing” display. The stored file is saved
with the following file name in the same folder as the ladder program file or CMOS
file that is being edited.
Opened file name + “. TMP”
Notes 1: Even if a CMOS. HEX file is read in and edited, the work file is output as a
ladder file (text file).
2: The data that is being edited in the “ladder editing” display is not stored.
23.5 Automatic Backup Function of the Read-in File (Original File)
When storing edited data, Ladder Editor 32NX has a function to automatically back
up the files before editing.