Operator`s manual

7
/
91
1 INTRODUCTION
1.1 Hardware Requirements for Ladder Editor 32NX
Ladder Editor 32NX operates with the configurations shown below.
OS
Japanese Microsoft Windows XP/2000
Required Memory
16 Mbytes or more
CPU
Pentium or Pentium compatible processor
Hardware Disk
Capacity for Installation
10 Mbytes or more
Disk Drive
Hard disk drive and CD-ROM drive
Display
Supported by MS-Windows
Mouse
Supported by MS-Windows
Robot Controller
NX100
Hardware Lock Key
Used under single user environment.
For details, refer to the following section “Hardware Lock.”
Note: A personal computer and OS are not included with this software.
Table 1.1 Hardware Requirements for Ladder Editor 32NX
For NX100 concurrent I/O, refer to the NX100 Concurrent I/O (Manual No.
RE-CKI-A442)
1.2 Hardware Lock Key
For proper operation, connect provided hardware lock key to personal computer
before using this software.
Two types of hardware lock keys are available;
- USB type
- D-sub type
Followings are the connecting methods of each key type.
Connecting of USB type key
Check and execute the following items
before connecting the key to USB port.
<Check the computing environment>
Multi-connection of USB type key is not available for one USB port because of
hardware structure. Therefore, only one key should be connected to one USB
port. When multi-connecting USB keys installing multiple offline software into
one personal computer, use the personal computer which is provided same
numbers of USB ports as the number of software to be installed.