Operator`s manual

3
/
91
CONTENTS
1 INTRODUCTION ...................................................................................................................... 7
1.1 Hardware Requirements for Ladder Editor 32NX............................................................... 7
1.2 Hardware Lock Key............................................................................................................ 7
1.3 Ladder Editor 32NX............................................................................................................ 9
1.3.1 What is Ladder Editor 32NX? ...................................................................................... 9
1.3.2 Features of Ladder Editor 32NX .................................................................................. 9
1.4 Teams .............................................................................................................................. 10
2 HOW TO INSTALL.................................................................................................................. 11
2.1 Execution of Setup Program ............................................................................................ 11
3 LADDER EDITOR 32NX BASIC DISPLAY ............................................................................. 13
4 FLOWCHART OF BASIC EDITING ........................................................................................ 14
5 STARTING AND ENDING LADDER EDITOR 32NX............................................................... 15
5.1 How to Start...................................................................................................................... 15
5.2 How to End ...................................................................................................................... 17
6 READING AND STORING EDITED LADDER FILES ............................................................. 18
6.1 Reading Ladder Data ....................................................................................................... 18
6.2 Reading Several Ladder Files.......................................................................................... 19
6.3 Storing Edited Data .......................................................................................................... 20
6.3.1 Storing when a Ladder Program File (CIOPRG.LST) is Open ................................... 20
6.3.2 Storing when a CMOS File (CMOS.HEX) is Open..................................................... 20
6.3.3 Storing a Ladder Program that is Being Edited.......................................................... 20
7 CREATING A LADDER DIAGRAM ......................................................................................... 21
8 EDITING A LADDER DIAGRAM ............................................................................................. 22
8.1 Ladder Parts Specifications.............................................................................................. 22
8.2 Selecting a Ladder Edited Line ........................................................................................ 22
8.3 Adding New Ladder Parts................................................................................................. 23
8.4 Deleting Ladder Parts ...................................................................................................... 24
8.5 Connecting and Disconnecting Lines between Ladder Parts ........................................... 24
8.5.1 Connecting with a Line .............................................................................................. 24
8.5.2 Disconnecting Two Parts ........................................................................................... 26
8.6 Setting Relay No., Register No. and Constants ............................................................... 27
8.6.1 Setting Values Using a Pop-up Menu ........................................................................ 27
8.7 Inputting Relay No. and Register No. Names .................................................................. 28
8.7.1 Setting Names Using a Pop-up Menu........................................................................ 29
8.8 Inserting Editing Matrix Row and Line.............................................................................. 30