Operator`s manual

29
/
91
The relay No. or register No. appears in the No. selection list box as shown
below.
Relay No. : #xxxxx, W#xxxxx
Register No. : Mxxx
Note: Some ladder parts have several relay Nos. or register Nos. In such a
case, several numbers appear in the No. selection list box.
Verify that the targeted relay Nos. or register Nos. appear and are selected in
the relay No. selection list box.
3. Set the name.
Two types of names, a short name and a long name can be used. They are
treated as follows with Ladder Editor 32NX.
Short name : Appears overlapped on the relay No. or register No. of
the ladder diagram in the “ladder editing” display.
(Refer to “23.8 Switching Short Name Display/
Non-Display”.)
Long name : Appears in the column of OUT relay names in the
“ladder editing” display, and in the row of output signal
names in the “ladder preview” display.
When setting is completed, be sure to click the [Update] button.
This button
records the setting information.
8.7.1 Setting Names Using a Pop-up Menu
Names can be also set in the following manner using the pop-up menu.
[How to Operate]
1.Select the ladder parts where the relay No. or register No. of the name to be
edited is set.
Right-click the mouse on the ladder parts where the relay No. or register
No. of the name to be edited is set in the “ladder editing” display, and the
pop-up menu appears. Select the [Edit Labels and Commonts], the [Edit
Labels and Commonts] dialog box appears.