Operator`s manual

27
/
91
8.6 Setting Relay No., Register No. and Constants
Relay No., register No. and constants can be set for each ladder parts. Set these
values in the following manner.
[How to Operate]
1. Enter the set value input mode.
Select [Tool] – [Edit Instruction] – [Edit Instruction Parameters.], or select
from the parts control tool bar (refer to “26.2.2 Parts Control Tool Bar”).
2. Select the ladder parts to which the set values are input in the “ladder editing”
display.
Left-click
the mouse on the ladder parts in the “ladder editing” display, and
the “set value input” dialog box appears.
Select type of set value.
Fig. 8-7 [Input Value] Dialog Box
Note: The number of setting items in the [Input Value] dialog box differs
depending on the ladder parts.
3. Input the set values.
Select the type of the set value in the combo box of the [Input Value] dialog box,
and then input a value suitable for the type of the set value.
Click the [OK] button to set the values.
8.6.1 Setting Values Using a Pop-up Menu
Set values can also be set in the following manner using a pop-up menu. The
pop-up menu appears by right-clicking the mouse.