Operator`s manual

23
/
91
To refer to the ladder image of a line that is not displayed on the display, scroll using
the scroll bar.
In the “ladder preview” display, right-click the mouse to select the line to be edited
and the “ladder editing” display with the ladder diagram of the selected line will
appear.
8.3 Adding New Ladder Parts
New ladder parts can be added when editing a ladder diagram.
Add ladder parts in the following manner.
[How to Operate]
1. Enter the parts addition mode (select parts to be added).
Selecting [Tool] – [Add Instructions] displays the list of ladder parts to be
added. Then select the ladder parts. Or select the parts to be added from
the ladder parts tool bar (refer to “26.2.4 Ladder Parts Tool Bar”).
Example) Adding the ladder parts of the NC contact
Select [Tool] – [Add Instructions] – [STR-NOT], or tool bar
.
2. Paste new parts on the matrix to be added in the “ladder editing” display.
When the ladder parts to be added are determined, the mouse form changes in
the “ladder editing” display. The selected ladder parts appear at the side of
the mouse pointer. Left-click
on the matrix location where the ladder parts
are to be added.
Fig. 8-2 Paste of Ladder Parts
Left-click