Operator`s manual

2.2 Control Instruction
2-28
2. B Variable number / LB Variable number / B [Array number] / LB [Array
number] / IG# (Input group number)
When a LABEL: is selected from the table in part 1 of this Explanation, choose one of the tags
from the following table.
3. ENTRY=Registration number
When a JET#(job registration table number) is selected from the table in part 1 of this Expla-
nation, add the following tag.
4. UF# (User coordinate number)
When JOB:, B variable number, LB variable number, B [Array number], LB [Array number],
IG# (Input group number), QUE, I Variable number, LI Variable number, I [Array number], LI
[Array number], D Variable number, LD Variable number, D [Array number], LD [Array num-
ber], or JET# (Job registration table number) is selected from the table in part 1 of this Expla-
nation,
the following tag can be added.
No Tag Explanation Note
10
B Variable num-
ber/
LB Variable num-
ber/
B [Array number]/
LB [Array num-
ber]
Specifies the byte type variable in which the
numerical value for the label is set.
11
IG#(Input group
number)
Specifies the input group number of the numeri-
cal value for the label.
No:1 to 128
B/I/D/LB/LI/LD Vari-
able can be used.
No. Tag Explanation Note
12
ENTRY=Registra-
tion number
Specifies the registration number of the job reg-
istered in the specified job registration table.
No.: 1 to 1024
Variable B/B[]/LB/
LB[]/I/I[] can be used.
No Tag Explanation Note
13
UF# (User coordi-
nate number)
Specifies the coordinates of the job. Available only in the
relative job function.