Operator`s manual

2.9 Spot Welding Instruction
2-266
2. MODE=Gun 1 operation mode
Add the following tag.
3. WTM=Gun 1 welding condition
Add the following tag.
No. Tag Explanation Note
2
MODE=Gun 1
operation mode
Specifies the operation mode of the air gun.
For a 2-gun system, specify the operation mode
of the first air gun.
Mode: 0 to 4
Variable B/B[]/LB/
LB[]/I/I[]/LI/LI[]/D/D[]/
LD/LD[] can be used.
Gun operation mode
The following table lists the settings and their operation modes.
For a 2-step stroke gun, make the settings according to the open status before and after
welding.
Setting Before Welding → After Welding
0 Single gun
1 Short open → Short open
2 Short open → Full open
3 Full open → Short open
4 Full open → Full open
No. Tag Explanation Note
3
WTM=Gun 1
welding condition
Specifies the welding condition number set for
the welder.
For a 2-gun welding system, set the welding con-
dition number of the first air gun.
Condition No.:
1 to 255
Variable B/B[]/LB/
LB[]/I/I[]/LI/LI[]/D/D[]/
LD/LD[] can be used.
SUPPLE-
MENT