Operator`s manual

2.7 Arc Welding Instruction
2-257
4. AN3=Aimed value of instruction voltage
The following tag can be added or omitted.
5. AN4=Aimed value of instruction voltage
The following tag can be added or omitted.
6. DIS=Execution section
The following tag can be added or omitted.
No Tag Explanation Note
8
AN3=Aimed value
of instruction volt-
age
Specifies the aimed value of the instruction volt-
age to analog output 3.
Aimed value:
-14.00 V to +14.00 V
Variable I/I[]/LI/LI[]
can be used.
(Units: 0.01 V)
No Tag Explanation Note
9
AN4=Aimed value
of instruction volt-
age
Specifies the aimed value of the instruction volt-
age to analog output 4.
Aimed value:
-14.00 V to +14.00 V
Variable I/I[]/LI/LI[]
can be used.
(Units: 0.01 V)
No Tag Explanation Note
10
DIS=Execution
section
Specifies the execution section where the cur-
rent and the voltage are modified.
The execution section is set by the distance from
the moving start point.
If the section is not specified, the entire section
of the move instruction is regarded as the execu-
tion section.
Section: 0.1 mm to
6553.5 mm
Variable B/I/D/B[]/I[]/
D[]/LB/LI/LD/LB[]/
LI[]/LD[] can be used.
(Units: 0.1 mm)
For details of the slope up/down function, refer to the “Operator’s Manual for the Arc Weld-
ing”.
SUPPLE-
MENT