Operator`s manual

2.7 Arc Welding Instruction
2-245
2. WEV# (Weaving condition file number)/AMP=Weaving single amplitude
Choose one of the tags from the following table.
3. FREQ=Weaving frequency
When AMP=Weaving single amplitude is selected from the table in part 2 of this Explanation,
add the following tag.
4. ANGL=Weaving angle
When AMP=Weaving single amplitude is selected from the table in part 2 of this Explanation,
the following tag can be added or omitted after the tag FREQ=Weaving frequency is selected
from the table in part 3 of this Explanation.
No Tag Explanation Note
5
WEV#(Weaving
condition file
number)
Specifies the weaving condition file number.
The condition when the weaving operates is reg-
istered in the weaving condition file.
No. : 1 to 16
Variable B/I/D/LB/LI/
LD can be used.
6
AMP=Weaving
signal amplitude
Specifies the amplitude of oscillation for weav-
ing.
Single amplitude:
0.1 mm to 99.9 mm
Variable B/B[]/LB/
LB[]/I/I[]/LI/LI[]/D/D[]/
LD/LD[] can be used.
(Units: 0.1 mm)
No. Tag Explanation Note
7
FREQ=Weaving
frequency
Specifies the weaving frequency. Frequency:
1.0 Hz to 5.0 Hz
Variable B/I/D/B[]/I[]/
D[]/LB/LI/LD/LB[]/
LI[]/LD[] can be used.
(Units: 0.1 Hz)
No. Tag Explanation Note
8
ANGL=Weaving
angle
Specifies the weaving angle. Angle:
0.1 deg. to 180.0
deg.
Variable B/I/D/B[]/I[]/
D[]/LB/LI/LD/LB[]/
LI[]/LD[] can be used.
(Units: 0.1 deg.)