Operator`s manual

2.7 Arc Welding Instruction
2-241
4. V=Welding speed
The following tag can be added or omitted.
5. AN3=Aimed value of instruction voltage
The following tag can be added or omitted.
6. AN4=Aimed value of instruction voltage
The following tag can be added or omitted.
No. Tag Explanation Note
8
V=Welding speed Specifies the speed while welding. Speed:
0.1 mm to 1500.0
mm/s.
Setting the parame-
ter S2C101 can
change the units.
Variable B/I/D/B[]/I[]/
D[]/LB/LI/LD/LB[]/
LI[]/LD[] can be used.
(Units: 0.1 mm/s)
No. Tag Explanation Note
9
AN3=Aimed value
of instruction volt-
age
Specifies the aimed value of the instruction volt-
age to analog output 3.
Aimed value:
-14.00 V to +14.00 V
Variable I/LI/I[]/LI[]
can be used.
(Units: 0.01 V)
No. Tag Explanation Note
10
AN4=Aimed value
of instruction volt-
age
Specifies the aimed value of the instruction volt-
age to analog output 4.
Aimed value:
-14.00 V to +14.00 V
Variable I/LI/I[]/LI[]
can be used.
(Units: 0.01 V)