Operator`s manual

2.7 Arc Welding Instruction
2-228
4. T=Time
When AC=Current output value is selected from the table in part 2 of this Explanation, the fol-
lowing tag can be added or omitted.
5. V=Welding speed
When AC=Current output value is selected from the table in part 2 of this Explanation, the fol-
lowing tag can be added or omitted.
6. RETRY
When AC=Current output value is selected from the table in part 2 of this Explanation, the fol-
lowing tag can be added or omitted.
7. REPLAY
When RETRY is selected from the table in part 6 of this Explanation, add the following tag.
No Tag Explanation Note
9
T=Time Specifies the timer value at the welding start. Unit: Seconds
Variable I/LI/I[]/LI[]
can be used.
(Units: 0.01 seconds)
No Tag Explanation Note
10
V=Welding speed Specifies the speed while welding. Speed: 0.1 mm to
1500.0 mm/s
Setting the parame-
ter S2C101 can
change the units.
Variable B/B[]/LB/
LB[]/I/I[]/LI/LI[]/D/D[]/
LD/LD[] can be used.
(Units: 0.1 mm/s)
No Tag Explanation Note
11
RETRY Specifies the RETRY function.
The RETRY function makes it so that the manip-
ulator does not stop and work is not interrupted
when an arc generation error occurs.
Refer to the supple-
ment “RETRY func-
tion”.
No Tag Explanation Note
12
REPLAY Specifies the REPLAY mode.
REPLAY mode is one of the operation modes.
When the RETRY function is available, the
ARCON processing can be done again.
Refer to the supple-
ment “RETRY func-
tion”.