Operator`s manual

2.3 Operating Instruction
2-139
SETFILE WEV#(1) (5) 3500
Changes the amplitude setting in the weaving condition file number 1 to 3.500 mm.
Element number of each condition file
The element number of each item in the condition file is shown below.
<Weaving condition file>
Element
No.
Item Units Remarks
1MODE
2 SMOOTHING
3 SPEED
4 FREQUENCY 0.1 Hz
5
AMPLITUDE (ACTIVE IN
SINGLE)
0.001 mm
6 PATTERN VERTICAL 0.001 mm
7 PATTERN HORIZONTAL 0.001 mm
8 PATTERN ANGLE 0.01 deg.
9 ANGLE 0.01 deg.
10
TIMER MODE
(SECT 1 to 4)
Stop positions 1 to 4
(SECT 1 to 4) desig-
nated by bit data
11 to14 MOVING TIME 0.1 sec. Sections 1 to 4
15 to18 TIMER (timer count) 0.1 sec.
Duration of a pause
between two sections.
19 HOVER WEAVING SET Optional
20 HOVER WEAVING TIME 0.01 sec. Optional
21
HOVER WEAVING INPUT
SIGNAL
Optional
For details of the weaving condition file, refer to “Chapter 11.10 Weaving Condition File” in
NX100 OPERATOR’S MANUAL FOR ARC WELDING (RE-CSO-A031).
SUPPLE-
MENT
Example