Installation Guide

Table Of Contents
Model: KL910702
KLRA4E08060H2B1P0D
KLRA4E09070H2B1P0D
KLRA4E060100H2B1P0D
FEATURES
LIGHTING:
AVAILABLE STANDARD SIZE:
24''x32''
28''x36''
40''x24''
- 5mm Copper free mirror.
- PVC backed.
- Mounting type: Vertically or horizontal.
- Energy Efficient and Long Lasting LED
Lighting.
- 3 Pin Plug/Hardwired.
CERTIFICATION:
- LED (Light-Emitting Diode).
- Defogger .
- Color Changeable.
- Power Source: Input: 110volts,50/60HZ.
- Energy saving LED lifetime approx
50,000 hours.
LED MIRROR
PRODUCT
MANUAL
When using an electrical furnishing, basic precautions should always be followed,
including the following. Read all instructions before using (this furnishing).
DANGER - To reduce the risk of electric shock:
Always disconnect this furnishing from the electrical outlet before cleaning.
WARNING -To reduce the risk of burns, fire, electric shock, or injury to persons.
1. Disconnect from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is us.ed by, or near children,
invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do
not use attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has damaged , not working properly, dropped or
damaged, or dropped into water. Return the furnishing to a service center for
examination and repair
5. Keep the cord away from heated surfaces.
6. Never operate the furnishing with the air openings blocked. Keep the air openings
free of lint, hair, and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
10. To disconnect turn all controls to the off position, then disconnect from outlet.
11. For grounded products the following statement:
"WARNING: Risk of Electric Shock - Connect this furnishing to a properly grounded
outlet only. See Grounding Instructions.
SAVE THESE INSTRUCTIONS
12. GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring system,
or an equipment-grounding conductor must be run with the circuit conductors
and connected to the equipment-grounding terminal or lead on the product.
IMPORTANT SAFETY INSTRUCTIONS
5020102

Summary of content (2 pages)