Installation Guide

Wrap the shower arm with teflon
tape.
Wrap teflon on long end of shower
arm, install it with flange.You can
keep original shower arm.sharp
cutout should be connect wall side.
Put the washer on diverter.
Connect the diverter and shower
arm on horizontal position.
Tighten free spinning nut clockwise with
wrench.If not,diverter will sway.
(Prevent scratch with cloth)
Turn on water supply and check all threaded
connections for leaks. If leaks occur, tighten
connection with an Adjustable Wrench or by
hand. Check Diverter for proper operation by
turning the side handle backward and forward
to activate the Fixed or Hand Showers.
How make this handheld holder
angle work properly if my water
outlet is flat or vertical?
Please Scan QR
Code to Watch
Video
2mm Hex driver
Put washer on extension arm and
connect it with diverter.
Put washer on rainfall shower head and
connect it with shower arm.
Tighten the rainfall shower head clockwise
with wrench.(Prevent scratch with cloth)
Tighten the hex nut on free spinning
nut for stability.
Tighten free
spinning nut
clockwise with
wrench.(Prevent
scratch with
cloth)
Hex nut connect diverter, concial nut
connect handheld shower head.
1
7
4
2
8
5
3
6
flat cutout
sharp cutout
Trouble shooting
on the back