Operation Manual
4
2.5 Power-on/off
1. Power on: When the battery can provide sufcient power, you can press the key Power and
hold on for two seconds to power on the Tablet. At the time, the Tablet may vibrate. After the
power-on process, the system will enter the screen-locking interface. You can slide rightward
the unlocking icon to enter the main interface.
2. Power off: First press and hold the key Power for 4 seconds, and the system will pop up the
interface for power-off conrmation. You can click the red icon at the right and power off the
Tablet, or click the key Cancel at the lower right corner to cancel the operation. In the latter
case, the system will return to the Power-Off interface.
3. Sleeping mode: Press the power switch for one second, and the system will enter the sleeping
mode, in which the LCD screen will turn black. In this mode, you can press any key to wake up
the system. Once waken up, the system enters the screen-locking interface. To save energy,
if the electricity is insufcient in the sleeping mode, the system can power off itself after it is
automatically powered on.
2.6 Vibration
Power-on/off vibration:
Click the setup icon
the shortcut bar, and select settings for the voice and display mode.
Then select or deselect the check box behind the “Haptic feedback”
2.7 Turning interface
The interface can be turned at times when the direction of the Tablet changes.
2.8 External network cable and USB stick
External network cable
Connect the port replicator to the Tablet and insert the network cable into the port of Ethernet.
Once logged in, the system will automatically obtain an IP address for network access. Network
access can also be realized through manual setups.
USB stick:
Connect the port replicator to the Tablet and insert the USB stick into the USB port. Once it is
properly connected, you can save and copy contents between the USB stick and the Tablet.
2.9 Network connection
Cable network:
After you insert the network cable into the port designed for Ethernet on the port replicator connected
to the Tablet, the icon “ETH” will appear on status bar at the top of the screen. Then the Tablet will
obtain the IP address automatically to access to the network. Network access can also be realized
through manual setups.
Wireless network:
1 Move leftward the WI-FI switch at the upper right part of the Tablet to be in the ON state;
2 Select the icon “setup” under the shortcut bar on the desktop;
3 Select “wireless network” in the setup menu;
4 Open WI-FI through the check box behind it;
5 Select “WI-FI setup” to set the WI-FI network;
6. All APs found by the Tablet will be listed. You can click the AP name to be connected;
7 If the connection is successful before the AP, the information of AP will be saved. To start connect-
ing, select “connect” in the popped-up window. To eliminate the AP information, select “forget”;
English
TAB310_manual_syl.indd 4 20-06-11 18:46