Operator`s manual

Installing the Blade Guard

Model Nos. 101PBC33. 101PBC33BH

and 101PLT25SS

See Fig. 15

Follow these steps to install the blade guard on

to the blade.

Fig. 15

1. Stop the brushcutter.

2. Remove the spark plug boot.

3. Fit blade guard around the outside of the

blade, taking care not to handle the blade

directly.

4. Ensure that each blade is covered by the

guard.

5. Connect the two ends together by locking

the pins into the notches of the blade

guard.

Operation – continued

When not in use, or when transporting the product as a brushcutter you should always

ensure the blade guard is in place. Failure to do so this may result in damage to the

blade or personal injury.

CAUTION:

Notch

Blade Guard