Operator`s manual

13
Attaching the Grass Deflector
Guard
NOTE: To protect the operator, always be sure
to attach the grass deflector.
To attach the Curved Shaft
Grass Deflector Guard to the
Line Trimmer
Model Nos. 101PLT25 and 101PLT25D
See Fig. 9
Fig. 9
Follow these steps to attach the curved shaft
grass deflector guard:
1. Position the grass deflector guard onto the
bottom of the curved shaft as shown.
2. Place the deflector bracket on the top of
the shaft.
3. Place the flat washer and locking washer
on the fixing screw.
4. Insert the fixing screw into the deflector
bracket and tighten. Repeat for other side.
To attach the Straight Shaft
Grass Deflector Guard
Model Nos. 101PBC33, 101PBC33BH
and 101PLT25SS
See Fig. 10
Follow these steps to attach the straight shaft
grass deflector guard.
Fig. 10
1. Unscrew the screws from the backing
plates on the grass deflector guard.
2. Position the grass deflector onto the
bracket at the base of the shaft as shown.
3. Insert the washers, locking washers and
the screws through the bracket, then
through the grass deflector.
4. Align the backing plate on the under side
of the deflector guard and use the
screwdriver to securely tighten together.
5. Repeat for the other side of the grass
deflector.
6. Ensure the grass deflector guard is
securely attached.
Assembly – continued
The line cutting blade on the grass
deflector guard is sharp. Avoid contact
with the blade. Failure to avoid contact
can result in serious personal injury.
WARNING:
Deflector Bracket
Grass Deflector
Guard
Gear Head
Screws
Bracket
Guard
Backing Plate