Operator`s manual

Assembly – continued
Installing the Ezy Load
Line Trimmer Head
Line Trimmer – Model No. 101PLT25D
See Fig. 7
Follow these steps to attach the Ezy Load Line
Trimmer Head Assembly.
1. Place the Ezy Load Line Trimmer Head
onto the threaded drive shaft.
2. Ensure that the recessed side of the disc
will be facing the ground when in use.
3. Attach nut and tighten securely with the
spanner provided.
Adding Cutting Line to the Ezy
Load Line Trimmer Head Assembly
Line Trimmer – Model No. 101PLT25D
See Fig. 8
NOTE: Only use line trimmer string between
2.4mm and 2.5mm thick.
Follow these steps to add cutting line to the
Ezy Load Line Trimmer Head.
1. Cut a length of cutting line measuring
approximately 44cm long.
2. Tie a knot in the middle of the line and
thread one side from the inside of the
Ezy Load Cutting Head to the outside.
3. Repeat for the other side that the knot is in
the middle of the Ezy Load Line Trimmer
Head.
4. If the line is too long for the cutting width of
the trimmer, the blade cutter on the safety
guard will automatically cut it down to the
correct size.
NOTE: The Ezy Load Line Trimmer Head can
be easily rethreaded while still attached to the
Line Trimmer. However, ensure that the engine
is switched off before rethreading. Failure to
switch off engine could result in serious injury if
the trimmer head starts to rotate.
12
Fig. 7
Fig. 8