Operator`s manual

Assembly – continued
Installing the Line Trimmer
Head Assembly
Brushcutter – Model Nos. 101PBC33,
101PLT25SS and 101PBC33BH
See Fig. 5
Follow these steps to attach the Line Trimmer
Head Assembly.
1. Align the hole in the gear head with the
slot in the male blade flange and insert the
4mm Allen key to prevent the gear head
from rotating.
2. If the blade is assembled, remove split pin,
blade nut, spring washer and female blade
flange from the gear head assembly.
3. Store safely for future use with the
brushcutting blade.
4. Thread the line trimmer spool onto the
threaded drive shaft, turning counter
clockwise until it is tight.
5. Remove Allen key.
Installing the Blade
Brushcutter – Model Nos. 101PBC33,
101PBC33BH and 101PLT25SS
See Fig. 6
Follow these steps to install the Brushcutter
blade.
Fig. 6
1. Align the hole in the gear head with the
slot in the male blade flange and insert the
4mm Allen key to prevent the gear head
from rotating.
2. Unscrew the female blade flange
completely, also removing the spring
washer, blade nut, and split pin.
3. Install the brushcutting blade, then
reassemble the female blade flange and
spring washer in this order onto the gear
shaft.
4. Attach the blade nut with the spark plug
wrench in a counter clockwise direction
until securely tightened.
5. Insert the split pin through the locking hole
and once through pull the pins apart to
lock in place.
6. Remove Allen key.
11
Be careful when handling the blade. It
is sharp. Failure to heed this warning
can result in serious personal injury.
WARNING:
If there is excessive vibration after
installing the blade, stop the engine
immediately. Excessive vibration of
blade means that it is not properly
installed. Check the blade, retighten or
reinstall as required.
WARNING:
Allen Key
Gear Head
Gear Head
Male Blade Flange
Male Blade
Flange
Hole
Hole
Blade
Spring Washer
Blade Nut
Split Pin
Female Blade
Flange
Fig. 5