Operator`s manual

Assembly
Attaching the Front Handle
(Model Nos. 101PLT25, 101PLT25SS,
101PLT25D, 101PBC33)
See Fig. 2
Follow these steps to attach the front handle.
1.
Remove the slotted screws provided to
separate the handle from the handle support.
2. Place the handle along the upper shaft to a
position that allows for comfortable operation.
3. Place the handle support on the bottom of the
tube on the opposite side of the front handle.
4. Secure the handle with the slotted screws provided.
Attaching the Shoulder Strap
Brushcutter – Model Nos. 101PBC33 and
101PBC33BH
Follow these steps to attach the shoulder
strap.
1. Connect the latch on the strap to the
hanger bracket.
2. Adjust the shoulder strap so that the
product hangs a few centimetres above
ground level. The cutting head and the
deflector guard should be level in all
directions.
3. Ensure the waist strap fits firmly around the
body and that the anti-vibration pad rests
on the hip.
NOTE: To release the product from the
shoulder strap, depress the lever and slide off
the hanger bracket.
Installing the Line Trimmer
Head Assembly
Line Trimmer – Model No. 101PLT25
See Fig. 4
Fig. 4
Follow these steps to attach the Line Trimmer
Head Assembly.
1. Install the Line Trimmer Spool by screwing
onto the threaded drive shaft.
2. Turn in a clockwise direction to tighten.
3. The Line Trimmer is ready to use.
10
Fig. 2
Handle
Barrier Bar
Slotted
screws
Handle
Support
Attaching the Bull-Bar Handles
(Model No. 101PBC33BH only)
See Fig. 3
Follow these steps to attach the bull-bar handles.
1. Loosen the nuts on the handle brace
attached to the shaft.
2.
Slide the right handle with the throttle control
into the right side of the handle brace.
3. Slide the left handle into the left side of the
handle brace.
4. Retighten nuts so that bull-bar handles are
secure.
Fig. 3