Installation Instructions

Installing Gate

Align the Top and Bottom Rails of the

Assembled Gate with the rails of the

existing fence. There must be adequate

clearance from the bottom rail to the

ground as well. (See Fig 6.)

Installing Striker & Latch

Attach Stiker (B) to the Gate in desired

location. Using the Striker as a guide

mount the Latch (C) to the Latch Post.

The Latch is set up for Right-Hand swing.

To reverse this, remove the spring and 2

bolts, flip the base and reinstall.

Fig 6. Align Gate

Fig 7.

Fig 8.

2. Use clamps to hold Hinged Brackets (D)

against the Hinge Post. Pre-drill and

install screws in both Hinged Brackets.

3. Adjust the hinges as necessary so the

gate is equally spaced between both

posts. (See Fig 7.)

Use of this product must be in accordance with all local & zoning and/or building codes.

Consumer assumes all risks and liability associated with the use of this product.

For warranty details see the express written limited warranty for your product.

Installing Hardware

1. The Hinged Brackets (D) and Jamb Brackets (E)

should be located on the Gate Jamb in line with

the Top and Bottom Rail.

2. Use the brackets as a guide and drill all holes,

being sure to pass through Gate Jamb and Top

Bottom Rail.

3. Secure the Brackets using supplied

nuts and bolts. Do not tighten fully.

4. Make sure the entire Gate assembly is square

and tighten all bolts using a 7/16" wrench.