User Manual

model no. 060-3823-0 | contact us 1.866.523.5218 model no. 060-3823-0 | contact us 1.866.523.5218
26
Problem Possible Reason Solution
The log
splitter
does not
split logs.
The log is not positioned correctly.
Refer to the Operation section for
instructions on proper log loading.
The size or hardness of the log
exceeds the capacity of the machine.
Reduce the size of the log before
splitting it on the log splitter.
The wedge cutting edge is blunt.
Refer to “Sharpening the blade”
under the Maintenance section for
instructions on how to sharpen the
cutting edge.
There is an oil leak.
Locate the leak, and call the
helpline.
An unauthorized adjustment was
made to the maximum pressure
limiting screw—a lower maximum
pressure was set.
Call the helpline.
The log pusher
moves jerkily,
makes an
unfamiliar
noise, or
vibrates
excessively.
Not enough hydraulic oil and too
much air in the hydraulic system.
Check the oil level, and refill the
oil if necessary. If the problem
persists, call the helpline.
Oil leaks
around the
cylinder ram
or from other
points.
Air was sealed in the hydraulic
system during operation.
Loosen the bleed screw by
3 or 4 rotations before operating
the log splitter.
The bleed screw was not tightened
before moving the log splitter.
Tighten the bleed screw before
moving the log splitter.
The hydraulic control valve
assembly and/or seal are worn.
Call the helpline.
Troubleshooting
65556CA01M130_GB.indd 26 2017/11/22 20:56:39