Use and Care Manual

YardStash Bicycle Cover Full Zip
Instructions
1. Fully unzip cover and spread out (inside out) on ground.
2. Locate label inside cover that is marked as “FRONT” with
red arrows.
3. Roll or lift your bicycle onto the cover (make sure your bike
is centered on the inside of the cover and the front of your
bike is facing towards the “FRONT” label).
4. Start covering your bike by holding your bike with one hand,
pulling the cover over the front wheel and lifting front sides
to rest on handlebars.
5. Zip front of cover over handlebars.
6. Complete zipping cover while lifting material up and over
seat and back tire.
7. Pull the draw strings on the front left and right sides of the
cover to tighten the fit on your bike as needed (fully loosen
the draw strings when removing your bike from the cover).
8. Optional: Insert chain through front lock vents to secure your
bike and cover.
!"#$%&'()&*(+&'()+&(+,-+.&/0-#1-&*--0&*+--&2(&3($2#32&)1&4*&'()&"#5-&
#$'&6)-17($1&(+&*--,8#3%9&:;;;<=>?@>AB?&(+&4$*(C'#+,12#1"D3(E&