Product Manual

2
Support Block
3
M8×16 (×9)
1
If the cutting disk surface is not cleaned properly and
the knives are not mounted ush on the cutting disk,
the knives could crack when the hardware is tightened.
Figure 15
Be careful and wear gloves when working near the
knives.
8. If knife show signs of wear, replace it. Using the 8mm hex
wrench, reach into the main housing and remove the two
socket head cap screws and the chipper knife. (See Figure 15)
M8×16 (×4)
21
Allen Key S8
4 mm
8 mm
5. Using Allen key S4 to remove the two screws on top of engine
shaft bushing. (See Figure 13, illustration 1)
6. Using Allen key S8 to remove the socket head cap screw xing
the engine shalt. (See Figure 13, illustration 2)
Figure 12 Figure 14
Figure 13
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
×
2
1
Allen Key S4
2
Allen Key S8
3
4 mm
8 mm
4 mm
8 mm
21
Triangle Hammer Slice
J-Type Hammer Slice
M12×55 (×4)
7. If the hammer slicers are damaged, remove the four M12×55
bolts that hold the J-type hammer slicer and triangle hammer
slicer, and replace.(See Figure 14)
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
4. Detach the rotor housing and hopper from the rotor disc seat.
(See Figure 12)
18
2-in-1 Chipper
»
Operator’s Manual
Maintenance
|
36060US25M100_KOHLER.indd 18 2017/10/17 11:06:18