Product Manual

ASSEMBLY
WHEELS
This chipper was partially assembled at the factroy, following the below assembly instructions to do asembling.
1. Slide a wheel assembly on to each end of the stub axle as seen in
Figure 1 Illustration 1. Place the at washer onto exposed axel. (See
Figure 1 Illustration 2) Take the cotter pin from Hardware Kit#1
and insert into and through the axle hole. Then, bend the ends of
the cotter pin. (See Figure 1 Illustration 3)
2. Align the three holes on the wheel axel bracket with the three
holes on the fan blower housing. (See Figure 2, Illustration 1) Then,
secure the wheel axel bracket with the three M8×12 bolts from
the Hardware Kit#2 as shown in Figure 2, Illustration 2.
Figure 1
Figure 2
× 2
1
M8 × 12 × 3
2
Wheel Shaft
1
2 3
Assembly Hole
1
2
M8 × 12 (×3)
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
9
|
Assembly
36060US25M100_KOHLER.indd 9 2017/10/17 11:06:04