Use and Care Manual

Forward
Figure 12a
Reverse Position
Forward Position
Figure 12b
STUCK LOG PROCEDURE
If a log does not split completely and becomes stuck on the wedge,
never attempt
to remove it by modifying the splitter or adding
attachments
to the splitter.
Move the control lever
to the Reverse positon and allow the
cylinder
to retract until the stuck log contacts the stripper plates.
Continue
to retract the cylinder until the log is dislodged from the
wedge.
Do not use the unit if the stripper plates are bent or
damaged. Bent or damaged stripper plates must be
repaired or replaced before use.
CONVERSION BETWEEN HORIZONTAL SPLITTING
POSITION AND VERTICAL SPLITTING POSITION
Horizontal Beam Lock
I lffflfJ.l.iffll@tfUI.J,
Lifting Handle
Operation I 20