Use and Care Manual

2. Hold the lifting handle and slowly lower the beam. It will lock
automatically. Double check
to make sure the beam bracket
is locked onto the beam.
~ Do not let the beam suddenly drop. Keep hands and
~ (lngers clear of pinch or crush points at all times.
Beam Lock Bracket
FigureBb
MANUAL TUBE
1. Remove the cap from the manual tube. Align the holes in the
manual tube
with the holes in the tow bar. Insert and tighten
bolts and washers.
(See Fipre 9)
Cap
Manual Tube
Figure9
M8X20
X2 ·=-
2. Reattach the cap.
LOG CRADLES
1. Align the holes on the right log cradle to the inside and lower
holes on the beam mounts. Insert the M12x35 bolts,
flat
washers, and nuts and securely tighten.
15 I Assembly
2. Follow step 1 to assemble the left log cradle. (See Fisure 10)
Figure 10
M12X35 XB
LOG TABLE (OPTIONAL)
Refer to Figures 10 and 11 to install the work table. Remove
the bolts,
flat washers, and nuts from the inside holes. Move
the log cradle from the incline position
to the horizontal
position. Align the holes on the log cradle
with the outside
holes on the beam mount. Reinstall the bolts,
flat washers,
and nuts.
Place the
work table over the holes in the log cradle and align
the 4 holes from
the work table plate and log cradle. Insert
and tighten
the M10x25 bolts, spring washers, flat washers,
and nuts.
'ti' ~ M10x25(x4l
WorkTable
Log Cradle (Right)
Figure 11
M10X25
X4 1111
YU2566PM02 -1703