Use and Care Manual
ASSEMBLY
This log splitter was partially assembled at the factory.
To
assemble your machine follow the below instructions.
WHEELS
1.
At
least
two
people are needed
to
move the reservoir outside
of
the pallet.
Place
the engine
at
the end corner
of
the pallet.
Reservoir
with
Engine
Figure2a
2.
Remove the
two
anti-dust sleeves from the wheel axle.
Anti-dust Sleeve
(lc2)
Figure2b
YU2566PM02
-1703
3.
Assistant holds the engine, while the
other
person assembles
the wheel opposite
of
the engine first.
Cotter
Pin (x1)
l
Anti-dust
Washel'(x1l
Figure2c
ll
@
M22
X2
4XSO
X2
[)
X2
4. Slide the wheel
with
the valve stem facing
out
to
the wheel
axle
and
the other roller bearing, then put the wheel washer
against the bearing.
Use
a 32mm socket
to
tighten the axle
nut
completely.
5.
Spin
the
wheel clockwise
or
counterclockwise
to
ensure
proper bearing seating.
6.
Loosen
the axle nut until
it
is
loose enough
to
turn
the wheel
with
your fingers.
7.
Retighten the axle nut until "finger tight."
Assembly
I 12