Instructions / Assembly
1. Beam with Cylinder
2. Reservoir with Engine
3. Beam Lock Bracket
4. Pivot Bracket
5. Log Cradle (Left)
6. Log Cradle (Right)
7. Wheels
8. Tow Bar
9. Manual Tube
10. Operator’s Manual and Engine Manual
11. Tools for Spark plug Assembly (YU2566 and YU2866 only)
12. Log Table (Optional)
13. Hardware Kit, Including:
CONTENTS SUPPLIED
Your YARDMAX log splitter comes partially assembled and contains the following:
ASSEMBLY
Remove the anti-dust sleeves from the two wheels. Take the
anti-dust washers and roller bearings from the wheels and
set aside for later use.
WHEELS
1.
Assistant holds the engine, while the other person assembles
the wheel opposite of the engine rst.
At least two people are needed to move the reservoir outside
of the pallet. Place the engine at the end corner of the pallet.
Remove the two anti-dust sleeves from the wheel axle.
4.
2.
3.
Reservoir with Engine
45
o
Use the shipping crate bottom
for balancing when installing
the wheel assembly.
Anti-dust Sleeve (x2)
Wheel Shaft
Slide the anti-dust washer and one roller bearing onto the
axle. Use a soft-faced hammer to tap the roller bearing lightly
to make sure the bearing is in the right position.
Slide the wheel with the valve stem facing out to the wheel
axle and the other roller bearing, then put the wheel washer
against the bearing. Use a 32mm socket to tighten the axle
nut completely.
Spin the wheel clockwise or counterclock wise to ensure
proper bearing seating.
Loosen the axle nut until it is loose enough to turn the wheel
with your ngers.
5.
7.
8.
6.
This log splitter was partially assembled at the factory. To assemble your machine follow the below instructions.
OPTIONAL
M22 X 2
1
4 X 50 X 2
X 2
M12 X 90 X 2
2
M10 X 25 X 4
3
20 X 110 X 1
4
Bridge Pin
X 1
M10 X 25 X 2
5
M8 X 20 X 2
6
M12 X 35 X 8
7
M10 X 25 X 4
8
M22 X 2
1
4 X 50 X 2
X 2
Anti-dust Washer (x2)
Anti-dust Sleeve (x4)
Roller Bearing (x4)
Axle Nut (x1)
Cotter Pin (x1)
Roller Bearing (x2)
Anti-dust Washer (x1)
Wheel Washer (x1)
Wheel
Cap
(x1)
32
mm
Figure 2a
Figure 2b
Figure 2c
Figure 2d
3
4
7
9
8
Handware Kit
OPTIONAL
12
1311
10
2
1
6
5
Heavy lifting required. Some of the components in these assembly instructions are heavy and can't be lifted by one person
safely. Please plan to assemble this product when another person can be available to help.
11 12
Gas Log Splitter
»
Operator’s Manual
|
Contents Supplied Assembly
|