Replacement Part List
Gas
Log Splitter » Operator's Manual
ASSEMBLY
This log splitter was partially assembled at the factory.
To
assemble your machine follow the below instructions.
WHEELS
1.
At
least
two
people are needed
to
move the reservoir outside
of
the pallet.
Place
the engine at the end corner
of
the pallet.
Reservoir
with
Engine
Figure2a
2.
Remove the
two
anti-dust sleeves from the wheel axle.
Anti-dust Sleeve (x2)
Figure2b
YU2566PM02- 1703
3.
Assistant holds the engine, while the other person assembles
the wheel opposite
of
the engine first.
Cotter
Pin(x1)
I
Anti-dust
Washertx1l
Figure2c
M22
4XSO
X2
X2
X2
4. Slide the wheel
with
the valve stem facing
out
to
the wheel
axle
and
the
other
roller bearing, then put the wheel washer
against the bearing.
Use
a 32mm socket
to
tighten the axle
nut completely.
5.
Spin
the
wheel clockwise
or
counterclockwise
to
ensure
proper bearing seating.
6.
Loosen
the axle
nut
until
it
is
loose enough
to
turn
the wheel
with
your fingers.
7.
Retighten the axle
nut
until "finger tight:•
Assembly
I 12