Operating Guide

Neutral Position
Reverse
Position
Figure 16a
Figure
16b
STUCK LOG PROCEDURE
Forward
Reverse Position
If a log does not split completely and becomes stuck on the wedge,
never attempt
to remove it by modifying the splitter or adding
attachments
to the splitter.
Move the control lever
to the Reverse positon and allow the
cylinder
to retract until the stuck log contacts the stripper plates.
Continue
to retract the cylinder until the log is dislodged from the
wedge.
Do not use the unit if the stripper plates are bent or
damaged. Bent or damaged stripper plates must be
repaired or replaced before use.
23 I Operation
CONVERSION BETWEEN HORIZONTAL SPLITTING
POSITION AND VERTICAL SPLITTING POSITION
Horizontal Beam Lock
M:fMp.l.i@iiNt.l.
~ Always lock the beam in the vertical position.
YS2565PM02- 1703