Operating Guide

7. Tow Bar
~@
M22 X1
8.
Log Stripper
4XSO X1
9.
Log Cradle (Left)
a)
X1
10. Log Cradle (Right)
~ @@@
M12X30 X4
11. Beam Lock Bracket
12. Muffler (YS2565 and YS2865 only)
~@
M22 X1
13. Operator's Manual and Engine Manual
4XSO X1
14. Tools for Spark Plug Assembly (YS2565 and YS2865 only)
a)
X1
15. Engine Oil
(]d (@)@ M10X25 X2
16. Log Table (Optional)
b
17. Hardware Kit, Including:
X1
@~
X1
[
0>@
18X135 X1
II
=
6X40 X2
~
Bridge Pin
X1
Qo @@
M8X20 xs
(t:::::D~@
Q;o @
M8X20 X2
1~·1
M10X35 X6
P @@@
M12X35 XB
IIIII
(t::::::D~@
M10X35 X4
II
(t:::D ~@
OPTIONAL
M10X20 X2
rt===o @ @@@
•II
Qo @H~ ©fJ
M10X25
M12X80 X2
ASSEMBLY
This log splitter was partially assembled at the factory. To assemble your machine follow the below instructions.
BEAM PIVOT BRACKET
1. Disassemble the triangle bracket from the left beam mount of
unit. (Remove the bolts and nuts, See Figure 2a.)
Figure2a
11 I Contents Supplied & Assembly
2. Follow the same procedure to disassemble the triangle bracket
from the right beam mount of unit.
3. Slowly pull the beam in a straight line until the pivot casing
in the tank pivot mount is locked by the U-shaped bracket in
the beam. Then make sure the hole in the beam pivot bracket
aligns with the pivot hole in the tank pivot mount. (See Figure
2b.)
If beam is pulled left or to the right, this could cause
instability of the product and could result in injury.
4. Insert the pivot bolt and secure with the bridge pin.
YS2565PM02- 1703