Operating Guide

FENDER
Align the left fender to the tank assembly. Insert the M8x20 bolts,
spring washers,
flat washers, and tighten by using a 13mm wrench.
(See Figure 10)
Follow the same procedure
to assemble the right fender.
Figure 10
M8X20
xa M#M
MANUAL TUBE
1. Remove the cap of the manual tube. Align the holes in the
manual tube with the holes in the tow bar, insert and tighten
bolts and washers.
(See Fipre 11)
2. Reattach the cap.
~
(Jp @
17 I Assembly
Cap
Figure 11
M8X20
X2 1[·1
MUFFLER (YS2565/YS2865 ONLY)
1. Remove the plastic sheet by loosening and removing the nuts
and washers, using a 13mm wrench.
Figure 12a
2. Install the muffler by aligning the screw holes on the muffler to
the screw holes on the engine. Reinstall the washer and nuts,
using a 13mm wrench.
Figure12b
VERTICAL POSITION TO HORIZONTAL POSITION
1. Remove the bridge pin and lock pin from the lower hole.
Upper
Hole
Lower Hole
Figure 13a
2. Hold the hydraulic cylinder handle and slowly lower the beam.
Insert the lock pin
into the upper hole. Make sure the beam is
locked in
the horizontal position.
A\ Do not let the beam suddenly drop. Keep hands and
~ (mgers clear of pinch or crush points at all times.
3. Attach the bridge pin in the lock pin.
YS2565PM02- 1703