Operating Guide

LOG STRIPPER (YS2565, YS2865, and YS3065 ONLY)
1. Align holes in the log stripper with the holes in the trunnion
mount.
2. Install the log stripper by tightening the M10x35 bolts, spring
washers,
and flat washers. (See Figure So)
Figure Sa
M10X35 X6
LOG STRIPPER (YS3567 ONLY)
1. Align holes in the log stripper with the holes in the trunnion
mount.
2. Install the log stripper by tightening the M10x35 and M10x20
bolts, spring washers, and flat washers.
(See Ffsure Sb)
(!C::::::D@@
~@@
13 I Assembly
Figure5b
M10X35
M10X20
TOW BAR
Insert the tow bar into the tank bracket and align the holes.
Connect
and tighten the tow bar to the tank by using the M12x80
bolts,
flat washers, spring washers, and nuts. (See Figure 6)
~X2
- ~
Tank Assembly
Bracket
Figure6
~ @ @@ @J M12X80
X2 -=·
WHEEL
1. Remove the two anti-dust sleeves from the wheel axle.
..
Anti-dust Sleeve (x2)
Figure7a
2. Remove the anti-dust sleeves from the two wheels. Take the
anti-dust washers
and roller bearings from the wheels and set
aside
for later use.
Roller Bearing(x4)
Figure7b
YS2565PM02- 1703