Operating Guide

Figure2b
Xl ll
Xl
18X135
Bridge Pin
5. Disassemble the support leg from the unit. (Remove the bolts
and nuts, see figure 2c.)
Figure2c
YS2565PM02 -1703
Gas Log Splitter » Operator's Manual
SPLIT CONTROL LEVER
1. Holding the hydraulic cylinder handle, pull out the cylinder
slowly
and in a straight line until the output shaft in the
cylinder
is against the trunnion mount and locked in the
U-shaped groove.
2. The control handle is shipped hanging from the valve on the
handle link.
Remove the pin and cotter pin from the control
handle. Move the control lever
to the vertical Neutral positon
(shown in circle on illustration
Fipre 3.)
3. Reinstall the pin and cotter pin to the control handle.
Figure3
HYDRAULIC CYLINDER HANDLE
Loosen two M 10 nuts by using a 16mm wrench. Change the handle
from the vertical position
to the horizontal position. Secure and
tighten the two M10 nuts. (See Flpre4)
Vertical Position
~:.iii~~;... Hydraulic Cylinder Handle
Horizontal Position
Figure4
Assembly I 12