Operating Guide

LOG SPINNER FOOT PLATE
)) The foot plate holds the log in place while the wedge
splits the log.
The
foot plate allows the operator to easily spin a log
)) in prep for splitting and allows the log to rotate when
splitting instead
of causing unnecessary stress on the
beam.
»
It is easy to replace when the grip teeth are damaged.
No repair welding
is required.
2-POSITION LOG CRADLE
)) The log cradles are designed to catch the log after it is split
2-position function -The first positon is to center
)) logs on the beam. The second position provides a flat
surface and worktable on which to put logs.
SPLIT CONTROL HANDLE
The control handle is used to move the wedge up
\.\. and down
to split logs. The control handle has three
// positions: Forward, Neutral, and Reverse. See the
"operation" section for instruction.
MANUAL TUBE
)) Keep manuals safely in the tube.
HORIZONTAL BEAM LOCK
)) The beam lock bracket is used to secure the beam in
the horizontal position.
YS2565PM02 -1703
Gas Log Splitter » Operator's Manual
HYDRAULIC CYLINDER HANDLE
\.\. The hydraulic cylinder handle is included for easy
// transition from horizontal to vertical.
2• BALL HITCH COUPLER
The coupler hitch is at the end of the tow bar and
)) attaches to a tow ball for transportation purposes.
LOG STRIPPER
)) The log stripper is designed to remove any partially
split wood from the wedge. This may occur while
splitting large diameter wood or freshly cut wood.
BEAM ASSEMBLY
)) The U-beam structural design is significantly stronger
than a typicall-beam design.
LOG TABLE (OPTIONAL)
)) A log table/platform can be mounted on the log cradle
directly.
ENGINE ON/OFF SWITCH
)) The engine switch has two positions. OFF- engine will
not start or run. ON- engine will start and run.
Know Your Machine I 20